BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Replacement of brake shoes
11.3. Removal and installation of brake disks
11.4. Removal and installation of supports
11.5. Replacement of brake shoes of the parking brake and their razzhimny mechanism
11.6. Adjustment of the parking brake
11.7. Removal and installation of cables and pedal of the drive of the parking brake
11.8. Removal of D/V of stoplights and pedal of a working brake
11.9. Removal and GTTs installation and its tank
11:10. Removal and installation of the one-pass valve of the vacuum amplifier
11:11. Removal and installation of the vacuum amplifier
11:12. Removal and installation of wheel sensors
11:13. Removal and installation of an electronic control unit of the ABS/ASC+T/DSC systems
11:14. Removal and installation hydromodulator of the ABS/ASC+T/DSC systems
11:15. Removal and installation of sensors of cross acceleration of DSC3
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment




11-12-snyatie-i-ustanovka-kolesnykh-datchikov.html

11:12. Removal and installation of wheel sensors

 PERFORMANCE ORDER

  1. Remove the corresponding wheel.
  1. Open the case of the socket (1), take out the socket (2) of the holder and separate it.
  1. At removal of the forward sensor extend a cable with the rubber plug from fastening on a suspension bracket rack.
  2. At removal of the back sensor take out a cable from holders on the shaking lever.
  1. Turn out a bolt (1) and remove the wheel sensor of the ABS system from an opening.
  1. Clear and grease with jellied Staburags NBU 12/K lubricant an opening under the wheel sensor.
  2. Installation is made upside-down. Be convinced of reliability of fixing of the socket, correctness of provision of a cable in holders and correctness of installation of the rubber plug.


"previous page
11:11. Removal and installation of the vacuum amplifier
following page"
11:13. Removal and installation of an electronic control unit of the ABS/ASC+T/DSC systems