BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
5.1. Engine cooling system
5.1.1. General information and precautionary measures
5.1.2. Removal and installation of a casing of the fan
5.1.3. Removal and installation of a radiator of the cooling system
5.1.4. Removal and installation of a broad tank
5.1.5. Removal and installation of the additional fan assembled with a casing
5.1.6. Removal and installation of the water pump
5.1.7. Removal and installation of the coupling of the drive of the fan
5.1.8. Removal and installation of the thermostat
5.1.9. Removal and installation of a collector of the cooling system
5.2. Systems of heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment


перевірити автомобілі на ДТП пошкодження


5-1-1-obshhaya-informaciya-i-mery-predostorozhnosti.html

5.1.1. General information and precautionary measures

General information and precautionary measures

The cooling system of the engine works on the following algorithm. Until the engine is heated-up, the cooling liquid (CL) is pumped over by constantly working water pump only in a head and the block of cylinders, and also in the heat exchanger of a heater of salon. At temperature increase of OZh to a certain level the thermostat opens a big contour of cooling and OZh circulates in addition through a radiator, being cooled with the air passing through it. At achievement of temperature of OZh of higher value the electric fan of the cooling system which creates an additional air stream through radiator edges for more intensive heat removal from it turns on.

1 — the Radiator
2 — the Broad tank
3 — the Heater of salon
4 — the Thermostat
5 — the Pump of cooling liquid

6 — the Block of cylinders
7 — Return
8 — Giving
9 — Podogrev of a butterfly valve
10 — the heater Crane

The water pump is given by a belt from a bent shaft.

Before work in a motive compartment, especially in the field of the radiator fan, surely disconnect a negative wire from the rechargeable battery and the fan electrical wiring socket since it can join because of effect of heat conductivity even at the switched-off ignition.

Do not open a cover of a broad tank of OZh or a radiator before full cooling of the engine in order to avoid a burn hot liquid or its steam.

If necessary to open a cover of a broad tank at the hot engine wind it with rags. Uncover slowly, gradually reducing vapor pressure.

The description of check and adjustment of the OZh level, replacement of OZh, and also some checks of the cooling system are provided in the Sections Check of Levels of Liquids, control of leaks, Check of a state and replacement of hoses and tubes in a motive compartment, localization of leaks and Replacement of cooling liquid of the Head Nastroyki and routine maintenance of the car.


"previous page
5.1. Engine cooling system
following page"
5.1.2. Removal and installation of a casing of the fan