BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
5.1. Engine cooling system
5.2. Systems of heating, ventilation and air conditioning
5.2.1. General information
5.2.2. Removal and installation of a heater
5.2.3. Removal and installation of a radiator of a heater
5.2.4. Removal and installation of fans and resistor assemblies
5.2.5. Removal and installation of the additional water pump and water valve
5.2.6. Removal and installation of deflectors of systems of heating, ventilation and To/in
5.2.7. Removal and installation of the K/V compressor
5.2.8. Removal of other components of the K/V system
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



5-2-8-snyatie-prochikh-komponentov-sistemy-k-v.html

5.2.8. Removal of other components of the K/V system

Evaporator, locking and safety valves

 PERFORMANCE ORDER

  1. Remove the block of heating and К/В.
  2. Remove the broad valve.
  1. Weaken collars from the left and right side and disconnect hoses.
  1. Take out from draft fastenings.

At installation bring both levers into extreme top situation and fix drafts.


  1. Turn out all screws and wring out all clamps of the lower part of the case. Remove the lower part of the case and take out isparitet.
  1. Give cap nuts (1) and remove the locking valve (2).

At installation replace sealing rings.


  1. Turn out screws (1) and remove the safety valve (2).

At installation replace sealing rings.

  1. Installation is made upside-down.

Dehumidifier tank

 PERFORMANCE ORDER

  1. Discharge the К/В system.
  2. Remove the right air cleaner.
  1. Turn out bolts, pull out the soaking-up and pressure head pipelines and their zakuporta up if the conditioner remains open more than one hours.

At installation replace sealing rings.


  1. Turn out bolts and pull out the dehumidifier tank up.
  1. Installation is made upside-down.



"previous page
5.2.7. Removal and installation of the K/V compressor
following page"
6. A power supply system and production of the fulfilled gases