BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
10.1. General information
10.2. Removal and installation of the driveshaft and elastic coupling
10.3. Replacement of the CV JOINT of the driveshaft
10.4. Replacement of an intermediate support of the driveshaft
10.5. Removal and installation of a reducer of the back bridge
10.6. Removal and installation of power shafts
10.7. Replacement of boots of power shafts
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment


индикатор тормозной системы

10-3-zamena-shrusa-kardannogo-vala.html

10.3. Replacement of the CV JOINT of the driveshaft

 PERFORMANCE ORDER

  1. Remove the driveshaft (see the Section Removal and installation of the driveshaft and elastic coupling).
  1. Remove a lock ring.

At installation use a new lock ring.


  1. Beat out bolts.

At installation do not forget to establish podkladny plates.


  1. Pull together a protective cover from the hinge.

At installation apply fresh lubricant on the CV JOINT from a corrugated boot and a flange of the leading gear wheel of the main transfer. Insert into the CV JOINT consolidation (1).


  1. Remove the CV JOINT by means of a stripper No. 26 1 070 or No. 26 1 110.
  1. Degrease a gear wreath and apply on it the fixing Loctite 648 sealant.

You watch that sealant did not get on a path of swing of balls. Selection (1) under consolidation has to be turned to a boot.


  1. Install the CV JOINT and pull it against the stop by means of a mandrel No. 23 1 040 or No. 24 1 040.

"previous page
10.2. Removal and installation of the driveshaft and elastic coupling		 following page"
10.4. Replacement of an intermediate support of the driveshaft