BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
10.1. General information
10.2. Removal and installation of the driveshaft and elastic coupling
10.3. Replacement of the CV JOINT of the driveshaft
10.4. Replacement of an intermediate support of the driveshaft
10.5. Removal and installation of a reducer of the back bridge
10.6. Removal and installation of power shafts
10.7. Replacement of boots of power shafts
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment

10-6-snyatie-i-ustanovka-privodnykh-valov.html

10.6. Removal and installation of power shafts

 PERFORMANCE ORDER

  1. Remove system of release of OG and the corresponding wheel.
  1. Turn out bolts.

At installation do not forget will establish lock plates (1).


  1. Give a nut with a fillet (1).

At installation use a new nut and its zakontrita.


  1. Vypressuyte a power shaft of a driving wheel by means of adaptation No. 33 2 111/116/117.
  1. On models with the device of regulation of a road gleam disconnect the cross lever of a suspension bracket from a support of the wheel bearing.
  1. Disconnect the shock-absorber from a wheel bearing support. Raise the elevator a support of the wheel bearing and remove a shaft.

At installation the head (1) from lyska of the rubber-metal hinge has to be turned to a bolt head.

  1. Press a power shaft of a wheel by means of adaptation No. 33 2 115/116/118.

"previous page
10.5. Removal and installation of a reducer of the back bridge		 following page"
10.7. Replacement of boots of power shafts