BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
10.1. General information
10.2. Removal and installation of the driveshaft and elastic coupling
10.3. Replacement of the CV JOINT of the driveshaft
10.4. Replacement of an intermediate support of the driveshaft
10.5. Removal and installation of a reducer of the back bridge
10.6. Removal and installation of power shafts
10.7. Replacement of boots of power shafts
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment




10-5-snyatie-i-ustanovka-reduktora-zadnego-mosta.html

10.5. Removal and installation of a reducer of the back bridge

 PERFORMANCE ORDER

  1. Remove system of release of OG and its thermofilters.
  2. Disconnect the driveshaft from a reducer of the back bridge (see the Section Removal and installation of the driveshaft and elastic coupling).
  3. Remove and tie up to a body power shafts of the left and right wheels (see the Section Removal and installation of power shafts).
  1. Prop up a reducer a jack No. 00 2 030 and adaptation No. 33 4 390.
  1. Turn out a bolt.
  1. Give nuts with left and with right the parties.

At installation use new самоконтрящиеся nuts.

  1. Installation is made upside-down. Make sure that the bolt (1) is inserted from the correct party. In conclusion check oil level in a case of a reducer and if necessary modify level.


"previous page
10.4. Replacement of an intermediate support of the driveshaft
following page"
10.6. Removal and installation of power shafts