12-3-2-snyatie-i-ustanovka-rychagov-i-rastyazhek-zadnejj-podveski.html

12.3.2. Removal and installation of levers and extensions of a back suspension bracket

The pushing bar / the integrated lever

If at dismantle the integrated lever was disconnected from the wheel shaking levers/support, then after installation it is necessary to perform measurement and/or adjustments of parameters of a running gear.

PERFORMANCE ORDER

Remove a back wheel and disconnect a power shaft from a reducer of the back bridge (see the Head Kardanny and power shafts, a reducer, differential and stupichny assemblies). To facilitate installation of a corner of disorder, mark with a core the provision of an eccentric bolt in relation to the shaking lever. Give a nut and a bolt. Turn out an eccentric bolt and to remove the integrated lever. Installation is made upside-down. Replace a nut of an eccentric bolt.

The shaking lever

PERFORMANCE ORDER

Remove a wheel and disconnect an electrical wiring of the wheel sensor of the ABS system (see the Head the Brake system). To facilitate installation of a corner of disorder, mark with a core the provision of an eccentric bolt in relation to the shaking lever (see an illustration). Give a nut of an eccentric bolt and take out it. Installation is made upside-down. Replace a nut of an eccentric bolt. Check and adjust the angles of installation of back wheels.

Top cross lever

If at dismantle the cross lever of a suspension bracket was disconnected from a beam of the back bridge, then after installation it is necessary to make check and adjustment of angles of installation of back wheels.

PERFORMANCE ORDER

Remove a back wheel and disconnect the shock-absorber from a wheel support (see the Section Removal and installation, dismantling and assembly of a rack of a suspension bracket). Give nuts. Nut of fastening of the top cross lever Nut of fastening of the top cross lever At installation use new самоконтрящиеся nuts. Clear of dirt and lubricant a conic pin and an opening in a wheel support. Installation is made upside-down.

Extension

PERFORMANCE ORDER

Remove a wheel and give nuts. Remove an extension. Installation is made upside-down. On a finger and in an opening there should not be lubricant traces. Use new nuts. Upon termination of installation check and adjust the angles of installation of back wheels.