BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.3.1. Removal and installation of assembly of a beam of a back suspension bracket
12.3.2. Removal and installation of levers and extensions of a back suspension bracket
12.3.3. Removal and installation of the stupichny bearing and its support
12.3.4. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



12-3-zadnyaya-podveska.html

12.3. Back suspension bracket

Removal and installation of assembly of a beam of a back suspension bracket

 PERFORMANCE ORDER

  1. Remove back wheels and the driveshaft (see the Head Kardanny and power shafts, a reducer, differential and stupichny assemblies).
  2. Pump out fuel from the right tank of the fuel tank, disconnect a hose from a jellied mouth of the fuel tank and muffle open openings (see the Head of the Power supply system and production of the fulfilled gases).
  3. Remove supports of the brake mechanism on both sides and suspend them on a body; remove back wheel sensors of the ABS system (see the Head the Brake system).
  1. Take out a cable of the drive of the parking brake from a connecting clip and remove the right arm of fastening of a cable from a body.
  1. Give a nut and disconnect the lever of the sensor of size of a road gleam. Remove the valve of adjustment of a road gleam from a beam of a back suspension bracket.
  1. Turn out bolts of fastening of the shock-absorber to a support of the stupichny bearing.

At installation the head (1) from lyska of the rubber-metal hinge has to be turned to a bolt head.


  1. Prop up the back bridge by means of support No. 00 2 030/040 and No. 33 4 220.
  1. To turn out the left and right bolts and to carefully lower the back bridge.

At installation of a hairpin (1) of a back basic heel have to be established parallel to a car axis.



"previous page
12.2.8. Removal and installation, dismantling and assembly of a rack of a suspension bracket
following page"
12.3.1. Removal and installation of assembly of a beam of a back suspension bracket