BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
6.1. General information and security measures
6.2. Power supply system of petrol engines
6.3. Power supply system of diesel engines
6.4. Systems of release and decrease in toxicity of the fulfilled gases
6.4.1. General information
6.4.2. Removal and installation of the supercharger of air of the SAI system
6.4.3. Removal and installation lambda probes
6.4.4. Removal and installation of system of release of OG
6.4.5. Replacement of mufflers
6.4.6. Removal and installation of the tank and adsorber of the EVAP system
6.4.7. Removal and installation of the EVAP valve
6.4.8. Removal and installation of a radiator of the EGR system
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment




6-4-6-snyatie-i-ustanovka-rezervuara-i-adsorbera-sistemy-evap.html

6.4.6. Removal and installation of the tank and adsorber of the EVAP system

 PERFORMANCE ORDER

  1. Remove a back left wheel and a loker of the left back wheel arch.

Tank

 PERFORMANCE ORDER

  1. Remove the returnable pipeline.
  1. Disconnect the tank and to lower it down.
  1. Remove collars.
  1. Release fuel-supply lines from fastening in a forward part of the tank. Disconnect from the tank fuel-supply lines to a coal adsorber and remove the tank.
  1. Installation is made upside-down.

Coal adsorber

 PERFORMANCE ORDER

  1. Give adsorber fixture.
  1. By means of special adaptation No. 16 1 050 unclench clamps of the soaking-up pipeline and a hose of ventilation of the fuel tank.
  1. Disconnect from an adsorber of the line of ventilation and the soaking-up hose. Remove an adsorber.
  2. Installation is made upside-down.


"previous page
6.4.5. Replacement of mufflers
following page"
6.4.7. Removal and installation of the EVAP valve