BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
6.1. General information and security measures
6.2. Power supply system of petrol engines
6.3. Power supply system of diesel engines
6.4. Systems of release and decrease in toxicity of the fulfilled gases
6.4.1. General information
6.4.2. Removal and installation of the supercharger of air of the SAI system
6.4.3. Removal and installation lambda probes
6.4.4. Removal and installation of system of release of OG
6.4.5. Replacement of mufflers
6.4.6. Removal and installation of the tank and adsorber of the EVAP system
6.4.7. Removal and installation of the EVAP valve
6.4.8. Removal and installation of a radiator of the EGR system
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment




6-4-7-snyatie-i-ustanovka-klapana-evap.html

6.4.7. Removal and installation of the EVAP valve

 PERFORMANCE ORDER

On models with the M52 engine separate the socket, disconnect hoses (1 and 2) from the valve and remove the EVAP valve from the holder the movement up.

The EVAP valve is located about a dome of the left rack of a suspension bracket.

Models with M60 and M62 engines

 PERFORMANCE ORDER

  1. On models with the M60 engine the valve of ventilation of the fuel tank is installed on a cover of GRM of cylinders No. No. 1 – 4.
  1. On models with the M60 engine weaken collars (1 and 3) and disconnect hoses. Separate the socket (2) and remove the EVAP valve from the holder.

On models with the M60 engine weaken the EVAP valve it is located about an arch of the left forward wheel. Separate the socket (1), weaken a collar (2) and disconnect a fuel hose. Open a clamp (3) and disconnect a hose.


At installation replace a collar and a fuel hose.

Models with the M73 engine

 PERFORMANCE ORDER

  1. Remove cases of both butterfly valves (see the Section Removal and installation of the case of a throttle, replacement of its laying).
  1. Mark and separate sockets of EVAP valves.
  1. Open quick-detachable collars of fastening of hoses of EVAP valves and disconnect hoses.
  1. Take out EVAP valves from the holder.
  1. Installation is made upside-down. Replace the bringing hoses to cases of butterfly valves together with collars.


"previous page
6.4.6. Removal and installation of the tank and adsorber of the EVAP system
following page"
6.4.8. Removal and installation of a radiator of the EGR system