BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
8.1. Manual box of gear shifting
8.2. Coupling
8.2.1. General information
8.2.2. Removal and installation of coupling
8.2.3. Replacement of the release bearing and fork of switching off of coupling
8.2.4. Replacement of the main cylinder of coupling
8.2.5. Replacement of the executive cylinder
8.2.6. Removal and installation of a pedal of coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment




8-2-3-zamena-vyzhimnogo-podshipnika-i-vilki-vyklyucheniya-scepleniya.html

8.2.3. Replacement of the release bearing and fork of switching off of coupling

 PERFORMANCE ORDER

  1. Remove RKPP (see Removal and the RKPP installation).
  1. Remove the coupling (1) of switching off of coupling.

At installation clear all surfaces (2) slidings of the coupling, – they have to adjoin to surfaces (3) slidings of a fork of switching off of coupling. To slightly grease the surfaces of sliding (2) of the release bearing.


  1. Remove a spring bracket (5) of a fork of switching off of coupling (4) then remove a fork.

At installation clear a coupling switching off fork.


  1. Slightly grease at a fork of switching off of coupling of a surface of sliding (1 and 2).
  1. Check a spring bracket (5) and a finger (6) with a spherical head for absence of damage and if necessary replace. Slightly grease a finger (6).
  1. To clear the directing plug (7).

Do not grease the directing plug since otherwise jamming on it the release bearing is possible.

  1. Installation is made upside-down.

On RKPP S6S 420G the spring bracket and a finger are subject to replacement.



"previous page
8.2.2. Removal and installation of coupling
following page"
8.2.4. Replacement of the main cylinder of coupling