BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
14.1. General information, diagnostics of malfunctions
14.2. Lighting fixtures
14.3. Screen wipers and washers
14.3.1. Removal and installation of levers and brushes of screen wipers
14.3.2. Removal and installation of an arm of levers of a screen wiper
14.3.3. Check and adjustment of angles of installation of levers of a screen wiper
14.3.4. Adjustment of nozzles of washing of a windshield
14.4. Other electric equipment
15. Schemes of electric equipment




14-3-1-snyatie-i-ustanovka-rychagov-i-shhetok-stekloochistitelejj.html

14.3.1. Removal and installation of levers and brushes of screen wipers

Removal and installation of levers and brushes of screen wipers

Brushes

 PERFORMANCE ORDER

  1. Bring screen wipers into vertical position. For this purpose include ignition and to install the switch of screen wipers on the interval mode. When screen wipers are at rest during a pause, switch off ignition, – they will rise in vertical position.
  1. To remove a plastic cover (1). Wring out a lock spring down, tighten a screen wiper brush to the lever and remove the movement up.

Screen wiper levers

The procedure of removal of the lever of a screen wiper from the driver differs from the corresponding procedure on the party of the forward passenger. Do not allow deformation of levers of a screen wiper at their dismantle.

Party of the driver

 PERFORMANCE ORDER

  1. Uncover, closing the screw (1), and turn out it.

At installation clear a carving of surplus of lubricant and install the new screw, having greased it with the fixing sealant.


  1. Give a nut (2) and remove the screen wiper lever.
  1. At installation screw the screw (1) in the direction of a pusher (3) so that the given size (A = 1.3 mm) between the lever (2) regulating clip force and the lever (4) screen wipers was sustained. A nut it will be easier profit if slightly to press the screen wiper lever to a windshield.

Party of the forward passenger

 PERFORMANCE ORDER

  1. Uncover, the closing nuts and give these nuts.
  1. Disconnect both levers of a screen wiper.


"previous page
14.3. Screen wipers and washers
following page"
14.3.2. Removal and installation of an arm of levers of a screen wiper