14-3-stekloochistiteli-i-omyvateli.html
14.3. Screen wipers and washers Removal and installation of levers and brushes of screen wipers Brushes
|
|
- Bring screen wipers into vertical position. For this purpose include ignition and to install the switch of screen wipers on the interval mode. When screen wipers are at rest during a pause, switch off ignition, – they will rise in vertical position.
|
|
- To remove a plastic cover (1). Wring out a lock spring down, tighten a screen wiper brush to the lever and remove the movement up.
|
|
|
Screen wiper levers
|
|
The procedure of removal of the lever of a screen wiper from the driver differs from the corresponding procedure on the party of the forward passenger. Do not allow deformation of levers of a screen wiper at their dismantle. |
Party of the driver
|
|
|
|
- Uncover, closing the screw (1), and turn out it.
|
|
|
At installation clear a carving of surplus of lubricant and install the new screw, having greased it with the fixing sealant. |
|
|
- Give a nut (2) and remove the screen wiper lever.
|
|
|
- At installation screw the screw (1) in the direction of a pusher (3) so that the given size (A = 1.3 mm) between the lever (2) regulating clip force and the lever (4) screen wipers was sustained. A nut it will be easier profit if slightly to press the screen wiper lever to a windshield.
|
|
|
Party of the forward passenger
|
|
|
|
- Uncover, the closing nuts and give these nuts.
|
- Disconnect both levers of a screen wiper.
|
|
|
|