BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
14.1. General information, diagnostics of malfunctions
14.2. Lighting fixtures
14.3. Screen wipers and washers
14.3.1. Removal and installation of levers and brushes of screen wipers
14.3.2. Removal and installation of an arm of levers of a screen wiper
14.3.3. Check and adjustment of angles of installation of levers of a screen wiper
14.3.4. Adjustment of nozzles of washing of a windshield
14.4. Other electric equipment
15. Schemes of electric equipment



14-3-2-snyatie-i-ustanovka-kronshtejjna-rychagov-stekloochistitelya.html

14.3.2. Removal and installation of an arm of levers of a screen wiper

Arm (assembled)

 PERFORMANCE ORDER

  1. Remove a box of airinflow and levers of a screen wiper (see the Section Screen wipers and washers).
  1. Record a cowl in assembly situation, having disconnected from it racks and having screwed bolts in loops.
  1. Turn out screws and uncover.
  1. Include screen wipers for a short time and switch off ignition that э / the motor of screen wipers stopped out of rest position.
  1. Separate the socket. If э / the motor of a screen wiper is faulty, remove the lever (1) and turn drafts and levers so that screws (2) became available.
  1. Turn out screws (2 and 3) and remove an arm of levers of a screen wiper.

Э / motor

 PERFORMANCE ORDER

  1. Remove an arm of levers of a screen wiper assembled.
  1. Give a nut (1) and remove the lever (2) from a shaft э / the motor. Turn out bolts (3) and remove э / the screen wiper drive motor.

At installation to fix bolts (3) allow only э / the motor.


  1. Remove an arm of levers of a screen wiper and activate a screen wiper until э / the motor rises in a condition of rest. Get the lever (1) on a shaft so that drafts (4 and 5) were on one line.


"previous page
14.3.1. Removal and installation of levers and brushes of screen wipers
following page"
14.3.3. Check and adjustment of angles of installation of levers of a screen wiper