14-4-2-snyatie-i-ustanovka-blokov-upravleniya.html

14.4.2. Removal and installation of control units

Door control unit

PERFORMANCE ORDER

Remove finishing of a door (see the Head Kuzov). Separate sockets, turn out screws and remove the door control unit.

Control unit of a sun-protection blind of back glass

PERFORMANCE ORDER

Remove partially a back of back sitting or the side panel of a back of the right back seat (see the Head Kuzov). Separate the socket (1), turn out the screw (2) and take out the control unit.

DU control unit

PERFORMANCE ORDER

Remove partially a back of back sitting or the side panel of a back of the left back seat (see the Head Kuzov). Separate the socket (1) and an antenna cable (2). Give a nut (3) and remove the DU control unit.

SRS control unit

PERFORMANCE ORDER

Disconnect a negative wire from the rechargeable battery. Wring out from each other a ventilating grate and a level or the control unit of a heater a little. Release from the top holders and take out a level or the control unit of a heater. Displace approximately on 30 ÷ 40 cm down and remove a ventilating grate. At installation get the central part of a ventilating grate and insert up to the end the movement up then establish a slip or the control panel of a heater. Separate sockets and remove a slip or the control panel of a heater. Give nuts and raise the SRS control unit. Before installation of the SRS control unit to track that the wire on weight was put on an adjusting hairpin (1). Separate the socket and remove the SRS control unit.