BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
13.1. External equipment and body elements
13.1.1. Removal and installation of a forward wing
13.1.2. Removal, installation and adjustment of doors
13.1.3. Removal, installation and adjustment of a cowl, replacement of its racks
13.1.4. Removal, installation and adjustment of a cover of the luggage compartment, replacement of its components
13.1.5. Removal and installation of a front bumper and its components
13.1.6. Removal and installation of a rear bumper and its components
13.1.7. Replacement and adjustment of mobile glasses of doors
13.2. Equipment of salon
14. Onboard electric equipment
15. Schemes of electric equipment




13-1-6-snyatie-i-ustanovka-zadnego-bampera-i-ego-komponentov.html

13.1.6. Removal and installation of a rear bumper and its components

Components of assembly of a front bumper

1 — the Overlay of a bumper
2 — the Chromeplated decorative side level
3 — the Side overlay of a bumper
4 — the Chromeplated decorative central level
5 — the Central overlay of a bumper
6 — the Rivet with the expansion plug
7 — the Bracket (the towing device)
8 — the Cover (the towing device)
9 — the Towing eye

10 — the Cover of a towing eye
11 — the Arm
12 — a self-tapping screw Washer
13 — the Self-tapping screw with a six-sided head
14 — a self-tapping screw Washer
15 — the Guide
16 — the Basic beam
17 — the Bolt with a cylindrical head
18 — the Washer
19 — the Shock damper
20 — Sealing laying


 PERFORMANCE ORDER

  1. Remove the central overlay of a rear bumper, from жав it from clamps a plastic wedge.
  1. Turn out a bolt of fastening and expansion bolts (1) from the left and right side and take off side aprons (2) wheel arches.
  1. Turn out bolts from the left and right side by means of special adaptation No. 51 1 080.
  1. Unclench clamps and disconnect a bumper from a guide from below.
  1. Delay a bumper a little back and take a bolt with a cylindrical head through an opening (2) by means of a magnetic core the movement sideways and up.

If it is not possible to take a bolt with a cylindrical head through an opening (2), if necessary, it is possible to make a small cut in the invisible place of a crossing point (1).

  1. Pull a bumper on yourself and remove it.
  2. When replacing a bumper rearrange from an old bumper on new decorative elements and a basic beam.

Central and side slips it is possible to replace without removal of a bumper, – wring out them from clamps by means of a plastic wedge.

  1. Installation is made upside-down.


"previous page
13.1.5. Removal and installation of a front bumper and its components
following page"
13.1.7. Replacement and adjustment of mobile glasses of doors