BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
6.1. General information and security measures
6.2. Power supply system of petrol engines
6.3. Power supply system of diesel engines
6.3.1. Principles of functioning of control systems of diesel engines
6.3.2. Removal and installation of the case of the air cleaner
6.3.3. Removal and installation of a turbocompressor
6.3.4. Removal and installation of the intercooler
6.3.5. Replacement of the sensor of pressure of pressurization
6.3.6. Removal and installation of the sensor of pressure in the fuel distributive highway
6.3.7. Removal and installation of the regulator of pressure and distributor of fuel
6.3.8. Replacement of the valve of a cut-off of supply of fuel
6.3.9. Removal and installation of fuel lines and fuel distributive highway
6.3.10. Removal and installation of the valve of preliminary heating
6.3.11. Removal and TNVD installation
6.3.12. Removal and installation of nozzles
6.3.13. Replacement of the fuel tank, his jellied mouth, and also fuel pump and sensors of a reserve of fuel
6.4. Systems of release and decrease in toxicity of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment

6-3-10-snyatie-i-ustanovka-klapana-predvaritelnogo-podogreva.html

6.3.10. Removal and installation of the valve of preliminary heating

The description for M57 and M67 engines is given below. The valve is in podkapotny space near the left head of the block of cylinders.


 PERFORMANCE ORDER

  1. Unclench collars (1) and the quick-detachable coupling (2).
  1. Remove the valve (3) of preliminary heating.
  2. Installation is made upside-down. If necessary replace a sealing ring of the coupling (2). Replace collars (1) of fastening of a hose.
  3. After installation pump over a power supply system, without allowing TNVD to work without fuel (dry).

"previous page
6.3.9. Removal and installation of fuel lines and fuel distributive highway		 following page"
6.3.11. Removal and TNVD installation












QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE