
BMW 7_aya the E38 series from 1994 to 2002
	1. Introduction
	2. Governing bodies and methods of operation
	3. Settings and routine maintenance of the car
	4. Engine
	5. Cooling systems of the engine, heating, ventilation and air conditioning
	6. A power supply system and production of the fulfilled gases
	7. Systems of electric equipment of the engine
	8. Manual box of gear shifting and coupling
	9. Automatic transmission
	10. Cardan and power shafts, reducer, differential and stupichny assemblies
	11. Brake system
	12. Suspension bracket and steering
		12.1. General information, recommendations and security measures
		12.2. Forward suspension bracket
			12.2.1. Removal and installation of a suspension bracket assembled
			12.2.2. Removal and installation of a beam of a suspension bracket
			12.2.3. Removal and installation of the left or right cross lever of a suspension bracket
			12.2.4. Removal and installation of extensions of levers and hinges of extensions
			12.2.5. Removal and installation of a rotary fist
			12.2.6. Removal and installation of the stupichny bearing
			12.2.7. Removal and installation of the stabilizer of cross stability and its rack
			12.2.8. Removal and installation, dismantling and assembly of a rack of a suspension bracket
		12.3. Back suspension bracket
		12.4. EDC system
		12.5. Steering
	13. Body
	14. Onboard electric equipment
	15. Schemes of electric equipment

Уменьшить диатезные мучения

12-2-3-snyatie-i-ustanovka-levogo-ili-pravogo-poperechnogo-rychaga-podveski.html

12.2.3. Removal and installation of the left or right cross lever of a suspension bracket

PERFORMANCE ORDER

Disconnect the cross lever of a suspension bracket from a beam of the forward bridge and a rotary fist.

At installation on both sides establish a washer (1), use new самоконтрящиеся nuts.

Turn out a bolt, install adaptation No. 31 2 200 in a cut and turn on a corner 90 °. Pull a rotary fist down.

By means of a stripper No. 31 2 240 disconnect the cross lever of a suspension bracket from a rotary fist.

At installation on landing cones there should not be lubricant traces.

Installation is made upside-down. By means of a jack raise a rotary fist before combination of a bolt with an opening of a plate (1), – the bolt has to enter this opening. Remove adaptation No. 31 2 200 and tighten bolts. Upon termination of works check the angles of installation of forward wheels.