BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.2.1. Removal and installation of a suspension bracket assembled
12.2.2. Removal and installation of a beam of a suspension bracket
12.2.3. Removal and installation of the left or right cross lever of a suspension bracket
12.2.4. Removal and installation of extensions of levers and hinges of extensions
12.2.5. Removal and installation of a rotary fist
12.2.6. Removal and installation of the stupichny bearing
12.2.7. Removal and installation of the stabilizer of cross stability and its rack
12.2.8. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment




12-2-7-snyatie-i-ustanovka-stabilizatora-poperechnojj-ustojjchivosti-i-ego-stojjki.html

12.2.7. Removal and installation of the stabilizer of cross stability and its rack

Stabilizer racks

 PERFORMANCE ORDER

  1. Establish car wheels in provision of the rectilinear movement.
  1. Disconnect a rack of the stabilizer of cross stability from a suspension bracket rack, holding fixing knot from a provorachivaniye a wrench.
  1. To disconnect a rack of the stabilizer of cross stability from the stabilizer, having given a nut and holding a hinge finger for a lyska a wrench.
  1. Remove a stabilizer rack.
  2. Installation is made upside-down. Use new самоконтрящиеся nuts. You watch that the brake hose was not clamped between a rack of the stabilizer and a resistant suspension bracket.

Stabilizer

 PERFORMANCE ORDER

  1. Remove a suspension bracket beam (see the Section Forward Suspension Bracket).
  2. Disconnect both racks of the stabilizer from the stabilizer (see an illustration).
  1. Give nuts from the left and right side of a body and remove the stabilizer of cross stability.
  1. Installation is made upside-down. Moisten a collar with water. Use new самоконтрящиеся nuts.


"previous page
12.2.6. Removal and installation of the stupichny bearing
following page"
12.2.8. Removal and installation, dismantling and assembly of a rack of a suspension bracket