BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.2.1. Removal and installation of a suspension bracket assembled
12.2.2. Removal and installation of a beam of a suspension bracket
12.2.3. Removal and installation of the left or right cross lever of a suspension bracket
12.2.4. Removal and installation of extensions of levers and hinges of extensions
12.2.5. Removal and installation of a rotary fist
12.2.6. Removal and installation of the stupichny bearing
12.2.7. Removal and installation of the stabilizer of cross stability and its rack
12.2.8. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



12-2-4-snyatie-i-ustanovka-rastyazhek-rychagov-i-sharnirov-rastyazhek.html

12.2.4. Removal and installation of extensions of levers and hinges of extensions

Installation or replacement of rubber-metal hinges of extensions of the right and left levers of a suspension bracket should be made at the same time.


 PERFORMANCE ORDER

  1. Remove protection of a case of the engine.
  1. Remove a suspension bracket lever extension.

At installation establish a washer (1), use new самоконтрящиеся nuts.


  1. Give a nut and a vypressuyta a spherical support by means of a stripper No. 31 2 240.

At installation on landing cones there should not be lubricant traces; use new самоконтрящиеся nuts.


  1. The rubber-metal hinge acts and pressed by means of a press and a mandrel No. 31 2 261/263.

At installation on the hinge and in an opening of an extension there should not be lubricant traces.


  1. The tag on the hinge has to be combined with a tag on an extension. At a press fitting the mandrel has to adjoin to the external plug of the hinge, – the maximum admissible not planeness makes ± 3 °.
  1. You watch that the ledge (A) made 12.5 ± 0.2 mm.
  1. Installation is made upside-down.


"previous page
12.2.3. Removal and installation of the left or right cross lever of a suspension bracket
following page"
12.2.5. Removal and installation of a rotary fist