BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
6.1. General information and security measures
6.2. Power supply system of petrol engines
6.2.1. Principles of functioning of a control system of the petrol engine
6.2.2. Removal and installation of the case of the air cleaner
6.2.3. Removal and installation of a branch pipe between a flowmeter of air and the case of a butterfly valve
6.2.4. Removal and installation of the case of a throttle, replacement of its laying
6.2.5. Removal and installation of the IAC valve
6.2.6. Removal and installation of the fuel distributive highway and injectors
6.2.7. Replacement of the regulator of pressure of fuel
6.2.8. Removal and installation of the fuel pump
6.2.9. Removal and installation of sensors of a reserve of fuel
6.2.10. Removal and installation of the fuel tank
6.2.11. Removal and installation of a fuel jellied mouth
6.3. Power supply system of diesel engines
6.4. Systems of release and decrease in toxicity of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



6-2-8-snyatie-i-ustanovka-toplivnogo-nasosa.html

6.2.8. Removal and installation of the fuel pump

 PERFORMANCE ORDER

  1. Empty the fuel tank.
  2. Remove the fuel reserve sensor in the right part of the fuel tank (see the Section Removal and installation of sensors of a reserve of fuel).
  1. Separate both sockets of an electrical wiring (1) on the fuel pump, unclench two collars (black shooters) of an electrical wiring plait, weaken a collar and accurately disconnect a spiral hose in the direction of a white arrow, without allowing damage of the union of the pump.

  1. Installation is made upside-down. Before installation straighten a connecting hose and a cable (1) between a cover (2) and the fuel pump (3) to avoid a tension.


"previous page
6.2.7. Replacement of the regulator of pressure of fuel
following page"
6.2.9. Removal and installation of sensors of a reserve of fuel




best canadian mail order pharmacies