6-2-9-snyatie-i-ustanovka-datchikov-zapasa-topliva.html
6.2.9. Removal and installation of sensors of a reserve of fuel
|
|
- Empty the fuel tank.
|
|
- Remove a back seat (see the Head Kuzov) and take out a rubber cap. Separate the isolating rug through perforation (dashed line) and cast away it.
|
|
|
The sensor in the right part of the fuel tank
|
|
|
|
- Verify 4 screws and uncover.
|
|
|
At installation pay attention to laying. |
|
|
- Separate the socket. Press a fuel-supply line, to weaken a collar and remove a fuel-supply line (on petrol engines – bringing, on diesel – drain).
|
|
|
- Give nuts, lift a cover as far as possible and cast away it upward.
|
|
|
Put a connecting hose under a cover, without fixing. |
|
|
- Press at the same time clamps of the fuel pump (the black case). If the case white, take out the fuel pump from a holder.
|
|
|
At installation be convinced of reliability of fixing of both clamps. Check installation of a sealing ring on the connecting union and, carefully pressing, if necessary put him into place. |
|
|
- Remove assembly of the fuel pump (1) and sensor (2) reserves of fuel.
|
|
|
Do not allow a sensor arm bend. At installation replace laying. |
- Remove the sensor from the fuel pump.
|
|
The sensor is delivered assembled with connecting hoses and sockets. |
- Separate both sockets (1) on the fuel pump. Weaken a collar (2) and accurately disconnect a spiral hose, without allowing damage of the union of the pump.
- Installation is made upside-down. Before installation straighten a connecting hose and a cable (1) between a cover (2) and the fuel pump (3) to avoid a tension.
|
|
The sensor in the left part of the fuel tank
|
|
The sensor of a reserve of fuel is fixed on the fuel tank by means of bayonetny connection. |
|
|
|
|
- Turn out 3 screws and uncover.
|
|
|
At installation pay attention to laying. |
- Separate the socket located under a cover.
|
|
- For removal of the sensor of a reserve of fuel insert a special key the ends into grooves on the sensor case. To turn a bayonetny lock counterclockwise before coincidence of a tag of "Auf" to an arrow on the fuel tank.
|
- Carefully take out the sensor, without allowing a bend of its arm.
- Installation is made upside-down. Replace rubber laying of the sensor. Insert the sensor so that tags of "Auf" coincided with an arrow on the fuel tank, and then turn the sensor before combination of a tag of "Zu" with an arrow on the fuel tank.
|
|
|
|