BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
9.1. General information
9.2. Search of malfunctions
9.3. Removal and AT installation and hydrotransformer
9.4. Removal and installation of the pallet of a case
9.5. Removal and installation of the PNP sensor
9.6. Removal and installation of the ATF filter and hydraulic block
9.7. Removal and installation Ý/m valves, regulators and sensors
9.8. Replacement of an arm of the mechanism of switching of the AT modes
9.9. Adjustment of the balance weight of switching
9.10. Adjustment of the lever of the selector
9.11. Adjustment and check of blocking of the lever of the selector
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



9-9-regulirovka-balansira-pereklyucheniya.html

9.9. Adjustment of the balance weight of switching

Adjustment of the balance weight of switching

 PERFORMANCE ORDER

  1. Install the lever of the selector (1) in situation "P" and weaken a nut (2).
  2. In order to avoid deformation of the hummock drive surely hold knot from a provorachivaniye adaptation No. 24 5 210 for tightening the screw.

It is possible to install adaptation No. 24 5 210 only when the lever is in situation "P".

  1. Translate the balance weight (3) forward (position of the parking), wring out draft (4) against the direction of the movement and again release it.
  2. Fix draft (4) by a nut (2), holding knot from a provorachivaniye adaptation No. 24 5 210.


"previous page
9.8. Replacement of an arm of the mechanism of switching of the AT modes
following page"
9.10. Adjustment of the lever of the selector