BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Replacement of brake shoes
11.3. Removal and installation of brake disks
11.4. Removal and installation of supports
11.5. Replacement of brake shoes of the parking brake and their razzhimny mechanism
11.6. Adjustment of the parking brake
11.7. Removal and installation of cables and pedal of the drive of the parking brake
11.8. Removal of D/V of stoplights and pedal of a working brake
11.9. Removal and GTTs installation and its tank
11:10. Removal and installation of the one-pass valve of the vacuum amplifier
11:11. Removal and installation of the vacuum amplifier
11:12. Removal and installation of wheel sensors
11:13. Removal and installation of an electronic control unit of the ABS/ASC+T/DSC systems
11:14. Removal and installation hydromodulator of the ABS/ASC+T/DSC systems
11:15. Removal and installation of sensors of cross acceleration of DSC3
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



11-11-snyatie-i-ustanovka-vakuumnogo-usilitelya.html

11:11. Removal and installation of the vacuum amplifier

 PERFORMANCE ORDER

  1. Remove GTTs (see the Section Removal and the GTTs installation and its tank) and the left lever of screenwash (see the Head Onboard electric equipment).
  1. Remove rubber consolidation (1), shift fixing brackets of a cover (2) towards the center of a windshield and take away a cover up.
  1. Turn out bolts and uncover.
  1. Uncover (1) and a conclusion (2) pipelines and disconnect a vacuum hose (3) from the vacuum amplifier.
  1. Remove D/V of stoplights (see the Section Removal of D/V of stoplights and a pedal of a working brake).
  1. Remove a bracket (1) and unhook a returnable spring (2).
  1. Take a bolt (3).

  1. Give nuts (1), turn out a bolt (2) and remove assembly of pedals from a partition of a motive compartment.

At installation use new самоконтрящиеся nuts.

  1. Slightly shaking the vacuum amplifier, disconnect him from a partition of a motive compartment.

In order to avoid damage of the vacuum amplifier do not use great efforts at his dismantling and assembly.


  1. Installation is made upside-down. Establish a washer (1), if necessary replace consolidation (2).

The detail (3) of the vacuum amplifier is very sensitive element and its damage can lead to failure of all amplifier.



"previous page
11:10. Removal and installation of the one-pass valve of the vacuum amplifier
following page"
11:12. Removal and installation of wheel sensors