BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
11.1. General information and security measures
11.2. Replacement of brake shoes
11.3. Removal and installation of brake disks
11.4. Removal and installation of supports
11.5. Replacement of brake shoes of the parking brake and their razzhimny mechanism
11.6. Adjustment of the parking brake
11.7. Removal and installation of cables and pedal of the drive of the parking brake
11.8. Removal of D/V of stoplights and pedal of a working brake
11.9. Removal and GTTs installation and its tank
11:10. Removal and installation of the one-pass valve of the vacuum amplifier
11:11. Removal and installation of the vacuum amplifier
11:12. Removal and installation of wheel sensors
11:13. Removal and installation of an electronic control unit of the ABS/ASC+T/DSC systems
11:14. Removal and installation hydromodulator of the ABS/ASC+T/DSC systems
11:15. Removal and installation of sensors of cross acceleration of DSC3
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



11-3-snyatie-i-ustanovka-tormoznykh-diskov.html

11.3. Removal and installation of brake disks

It is necessary to replace brake disks in pairs, i.e. on both wheels of one axis. At the same time it is also necessary to replace brake shoes (see the Section Replacement of Brake Shoes).


 PERFORMANCE ORDER

  1. Remove wheels. If necessary remove and clear brake shoes (see the Section Replacement of Brake Shoes).
  2. Turn out bolts of fastening of a support and suspend it on a body, without disconnecting a brake hose.
Bolts (1) of fastening of a support of the back brake mechanism
Bolts of fastening of a support of the forward brake mechanism

The brake hose should not test at the same time tension.


  1. Turn out a bolt and remove a brake disk.

For a reversing of bolts of fastening of a brake disk it is not allowed to beat with the hammer or something similar a frictional ring! If necessary carefully knock with the hammer with soft brisk on the basis of a brake disk.

  1. Carefully clear the plane of interface to a brake disk on a wheel nave, if necessary remove corrosion traces. Roughnesses on the interfaced plane can lead to a buckling of a brake disk.
  2. The ventilated brake disks are balanced by means of the balancing brackets established on the internal diameter of a disk, – do not delete and do not move them.
  3. Measure thickness of a brake disk and if necessary replace it.
  4. Installation is made upside-down. Upon completion of works on the back brake mechanism adjust the parking brake (see the Section Adjustment of the Parking Brake).


"previous page
11.2. Replacement of brake shoes
following page"
11.4. Removal and installation of supports