12-5-5-zamena-rychaga-regulirovki-rulevojj-kolonki.html

12.5.5. Replacement of the lever of adjustment of a steering column

Design of the lever of adjustment of a steering column

1 — the Nut 2 — the Bearing 3 — Tightening a disk	4 — the Clamp 5 — the Lever 8 — the Torsion spring 9 — Tightening adaptation

PERFORMANCE ORDER

Remove the top and lower casings of a steering column (see the Section Removal and installation of casings of a steering column). Remove the wooden panel and the finishing panel of a ware box at the left. Release the torsion spring (8) on both sides, give a nut (1) and remove the persistent bearing (2), tightening a disk (3) and a clamp (4). Vypressuyte by means of special adaptation No. 32 1 200 and a nozzle No. 32 1 204 tightening adaptation (9) from the lever (5) of adjustment of a steering column. Hold adaptation for lysk with a wrench. The lever of adjustment has to look at the lock of a shaft of a steering column, and the tetrahedral head of tightening adaptation should be brought to an opening of a pipe of an arm of fastening of a steering shaft. Press tightening adaptation (9) by means of special adaptation No. 32 1 200 in the lever (5) of adjustment of a steering column. Put on a clamp (4), tightening a disk (3) and the persistent bearing (2). Insert the torsion spring (8) on both sides. Replace a nut (1).