BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
12.5.1. Principle of work of GUR
12.5.2. Removal and installation of a steering wheel, block of a safety cushion and its contact ring
12.5.3. Removal and installation of casings of a steering column
12.5.4. Removal and installation of assembly of a steering column and sensor of an angle of rotation
12.5.5. Replacement of the lever of adjustment of a steering column
12.5.6. Removal and installation of the lock of ignition and blocking of a steering wheel
12.5.7. Removal and installation of the steering mechanism from GUR
12.5.8. Removal and installation of steering drafts, bipod and pendular lever
12.5.9. Removal and installation of the pump GUR
12.5.10. The angles of installation of wheels of the car - the general information
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment

12-5-9-snyatie-i-ustanovka-nasosa-gur.html

12.5.9. Removal and installation of the pump GUR

Reuse of the lowered GUR liquid is not allowed.


 PERFORMANCE ORDER

  1. Remove protection of a case of the engine.
  2. Take off a pump GUR drive belt (see the Head Dvigatel).
  3. Disconnect pipelines from the pump GUR.

Connection of pipelines to the bladed pump

1 — To steering
2 — To the tank

Connection of pipelines to the tandem pump

1 — To steering
2 — To the tank
3 — To the regulator of a road gleam

At installation replace sealing laying of pipelines.


  1. Give a nut.

At installation fix a hairpin (1) on the pump, tighten a nut (2) by hand towards an arm of a support of the engine and tighten a nut (3).


  1. Turn out bolts of fastening of the pump to an oil case and remove the pump.
  1. Installation is made upside-down.

"previous page
12.5.8. Removal and installation of steering drafts, bipod and pendular lever		 following page"
12.5.10. The angles of installation of wheels of the car - the general information