BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
3.1. General information
3.2. General information about settings and adjustments
3.3. Schedule of routine maintenance
3.4. Check of levels of liquids, control of leaks
3.5. Check of a state and replacement of hoses and tubes in a motive compartment, localization of leaks
3.6. Replacement of motive oil and oil filter
3.7. Clearing and replacement of the fuel filter
3.8. Check of the brake system and coupling
3.9. Check of a condition of system of production of the fulfilled gases
3.10. Check of a condition of components of a suspension bracket and steering
3.11. Check of a condition of protective covers of CV JOINTS of power shafts
3.12. Replacement of the AT gearbox oil
3.13. Replacement of brake fluid and pumping of the brake system
3.14. Replacement of spark plugs
3.15. Replacement of the saloon filter (system of ventilation)
3.16. Replacement of the filtering air cleaner element
3.17. Replacement of cooling liquid
3.18. Check of a condition of tires and pressure of their rating
3.19. Check of a condition of the battery and care of it
3.20. Check of a condition of a belt of the drive of auxiliary units
3.21. Check of a condition of brushes of screen wipers and adjustment of nozzles of washers
3.22. Replacement of oil of the main transfer
3.23. Check of thickness of the conducted clutch plate
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



3-17-zamena-okhlazhdayushhejj-zhidkosti.html

3.17. Replacement of cooling liquid

Replacement of OZh should be made on the cold engine.

Additional information on the cooling system is provided in the Head of the Cooling system of the engine, heating, ventilation and conditioning.


 PERFORMANCE ORDER

  1. Install temperature regulator in the provision of a heater in the provision of the maximum temperature. Uncover a radiator.
  2. Car front also establish to Poddomkratta it on props. Remove the lower protection cover of a motive compartment and substitute under a radiator capacity for collecting the following OZh.
  3. On M52 and M62 engines turn out an opening stopper for pumping of the cooling system and a stopper of drain openings from the left and right side of the block of cylinders.
Opening stopper for pumping of the cooling system of the M62 engine
Opening stopper for pumping of the cooling system of the M52 engine
Traffic jams in the block of cylinders of the M62 engine
  1. Turn out a stopper of a drain opening in the bottom of a radiator and let's liquid flow down completely.
  1. Tighten the removed traffic jams with the required effort.
  2. Fill a broad tank with cooling liquid according to requirements of Specifications.
  3. Turn out an opening stopper for pumping of the cooling system and wait until OZh with bubbles ceases to act. Tighten a stopper.

On diesel models pumping of the cooling system happens automatically through the top tube to a separate broad tank.

  1. Establish a cover of a radiator and a broad tank.
  2. Modify the OZh level and check the cooling system for existence of leaks (see the Section Check of Levels of Liquids, control of leaks).


"previous page
3.16. Replacement of the filtering air cleaner element
following page"
3.18. Check of a condition of tires and pressure of their rating