BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of compression pressure
4.3. Check of the engine by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.5. M62 engine
4.5.1. Removal and installation of covers of heads of cylinders
4.5.2. Removal and installation of heads of the block of cylinders
4.5.3. Removal and installation of the top section of the pallet of a case and oil pump
4.5.4. Removal and installation of the pallet of a case
4.5.5. Removal and installation of covers of a chain of GRM
4.5.6. Replacement of epiploons of a bent shaft and consolidations of distributors of ignition
4.5.7. Removal and installation of a flywheel
4.5.8. Removal and installation of a damper of tortional fluctuations
4.5.9. Removal and installation of driving belts
4.5.10. Removal and installation of the oil pump
4.5.11. Removal and installation of inlet pipelines
4.5.12. Removal and installation of final collectors
4.5.13. Removal and installation of the engine
4.6. Diesel M57 engine
4.7. Diesel M67 engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment

4-5-8-snyatie-i-ustanovka-dempfera-krutilnykh-kolebanijj.html

4.5.8. Removal and installation of a damper of tortional fluctuations

 PERFORMANCE ORDER

  1. Remove the cooling system fan drive coupling (see the Section Removal and installation of the coupling of the drive of the fan of the Head of the Cooling system of the engine, heating, ventilation and conditioning).
  2. Take off driving belts (see the Section Removal and installation of driving belts).
  3. Remove the left and right loker of forward wheels.
  1. Turn out a bolt and remove the holder.
  1. Take aside an air branch pipe of an obduv of the generator, and also the left and right channels of an obduv of brake mechanisms.
  1. Remove a pulley of the water pump.
  1. Turn out the central bolt of a pulley.
  1. Holding a damper by means of adaptation No. 11 2 420, turn out the central bolt of a damper and remove it.

To avoid damage of a support of the engine, establish between it and adaptation wooden laying.
  1. Installation is made upside-down. Use a new central bolt of fastening of a damper of tortional fluctuations.

"previous page
4.5.7. Removal and installation of a flywheel		 following page"
4.5.9. Removal and installation of driving belts












QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE