BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of compression pressure
4.3. Check of the engine by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.5. M62 engine
4.6. Diesel M57 engine
4.6.1. Removal and installation of a head of cylinders, camshafts and their asterisks
4.6.2. Removal and installation of the top section of the pallet of a case
4.6.3. Removal and installation of a cover of the GRM drive
4.6.4. Replacement of epiploons of a bent shaft
4.6.5. Removal and installation of a flywheel
4.6.6. Removal and installation of a damper of tortional fluctuations
4.6.7. Replacement of driving belts and their natyazhitel
4.6.8. Removal and installation of the oil pump
4.6.9. Removal and installation of the oil cooler
4.6.10. Removal and installation of the inlet pipeline
4.6.11. Removal and installation of a final collector
4.6.12. Removal and installation of the vacuum pump
4.6.13. Removal and installation of the engine
4.7. Diesel M67 engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment

4-6-5-snyatie-i-ustanovka-makhovika.html

4.6.5. Removal and installation of a flywheel

 PERFORMANCE ORDER

  1. Remove RKPP together with coupling or AT (see the Head the Manual box of gear shifting and coupling or Automatic transmission).
  1. Record a flywheel by means of special adaptation No. 11 2 170.
  1. Turn out bolts of fastening of a flywheel.
  1. On a flange of a bent shaft clear carving openings under bolts of fastening of a flywheel.
  1. Installation is made upside-down. Position of the aligning plug (1) in a two-mass flywheel is noted by two notches near the corresponding opening of the threaded connection. Use new bolts of fastening of a flywheel.

"previous page
4.6.4. Replacement of epiploons of a bent shaft		 following page"
4.6.6. Removal and installation of a damper of tortional fluctuations