BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
13.1. External equipment and body elements
13.2. Equipment of salon
13.2.1. Removal and installation of window regulators
13.2.2. Removal and installation of finishing and sound insulation of a forward door
13.2.3. Removal and installation of finishing and sound insulation of a back door
13.2.4. Removal and installation of panels of finishing of racks of a body and ceiling
13.2.5. Removal and installation of finishing of the dashboard
13.2.6. Removal and installation of the shelf behind a back seat and blinds of back glass
13.2.7. Removal and installation of overlays of thresholds of doors
13.2.8. Removal and installation of elements of finishing of the luggage compartment and its cover
13.2.9. Removal and installation of front seats
13.2.10. Removal and installation of a back seat
13.2.11. Removal and installation of seat belts
13.2.12. Removal and installation of a cover of the top hatch
14. Onboard electric equipment
15. Schemes of electric equipment




13-2-1-snyatie-i-ustanovka-steklopodemnikov.html

13.2.1. Removal and installation of window regulators

Removal and installation of window regulators

Forward door

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the rechargeable battery.
  2. Adjust the provision of glass of a forward door (see the Section Replacement and adjustment of mobile glasses of doors).
  3. On models with a side safety cushion remove it.
  1. Unhook and remove the internal handle of a door.
  1. Wring out a socket clamp down, move the lever down and separate the socket (1) electrical wiring of the loudspeaker. Turn out bolts and remove a box (2) dynamics.
  1. Separate the socket (1), turn out bolts (3) and remove the control unit (4). Cut collars of fastening of a plait of an electrical wiring and remove holders (2) electrical wirings (rivets with expansion plugs). Completely remove a sound-proof covering.
  1. Lift glass (1) up and record it in this situation with the help of a wooden wedge (2). Separate the window regulator drive electrical wiring socket, turn out bolts (only to weaken 3 lower bolts) and remove the hummock drive of a window regulator assembled.
  1. Installation is made upside-down. Pay attention to the next moments.
  1. Establish a window regulator in an angular arm and insert all bolts, without tightening them it is final. Tighten bolts (1 and 2).
  1. Insert glass into clips of a window regulator and adjust the provision of glass.
  1. Lower glass against the stop and tighten bolts (3 and 4).
  1. Lift glass against the stop and tighten bolts (5 and 6).

Back door

 PERFORMANCE ORDER

  1. Remove glass of a back door (see the Section Replacement and adjustment of mobile glasses of doors).
  1. Turn out bolts, separate the socket and remove a window regulator (1).


"previous page
13.2. Equipment of salon
following page"
13.2.2. Removal and installation of finishing and sound insulation of a forward door